| rdfs:comment
| - The L64 was an intermediate calibre British bullpup layout prototype assault rifle developed in the 1970s. At one time it was known as the 4.85 Individual Weapon, a reference to the calibre of the bullet it fired. The Royal Small Arms Factory developed a rifle to fire the new round. The new L64/65 "Individual Weapon" was outwardly similar to the earlier EM-2, but adopted a firing mechanism very similar to ArmaLite's latest AR-18 design. The first examples were available in 1972. The L64 pattern was later developed into the SA80 family of weapons, which entered service with the UK in the 1980s.
- The L64 was an intermediate calibre British bullpup layout assault rifle developed in the 1970s. The British had considered bullpup designs with intermediate calibre rounds in the 1950s; though one, the EM-2, had been on the point of being introduced it had been dropped when a full calibre round was adopted as the NATO standard. The Royal Small Arms Factory developed a rifle to fire the new round. The new L64/65 "Individual Weapon" was outwardly similar to the earlier EM-2, but adopted a firing mechanism very similar to Armalite's latest AR-18 design. The first examples were available in 1972.
|
| abstract
| - The L64 was an intermediate calibre British bullpup layout assault rifle developed in the 1970s. The British had considered bullpup designs with intermediate calibre rounds in the 1950s; though one, the EM-2, had been on the point of being introduced it had been dropped when a full calibre round was adopted as the NATO standard. In the 1970s, the British Army started looking again at new assault rifle designs, using lighter rounds than the then standard-issue 7.62mm L1A1 SLR used. Their research suggested that a slimmer bullet of the same general weight as the M16's 5.56x45 mm (.223") would result in the same ability to be fired in fully automatic mode, while having much better penetration and ballistics. The result was the .190-inch (4.85 mm) round fitted in "necked down" but otherwise standard 5.56mm cartridges from the M16. The Royal Small Arms Factory developed a rifle to fire the new round. The new L64/65 "Individual Weapon" was outwardly similar to the earlier EM-2, but adopted a firing mechanism very similar to Armalite's latest AR-18 design. The first examples were available in 1972. By 1976, NATO was ready to standardize on a small calibre round. The testing of the various rounds head-to-head started in 1977. The British round out-performed the standard US 5.56 mm. However Fabrique Nationale's entry based on the 5.56 mm, the "SS-109" performed as well as the British cartridge. In the end it was selected largely due to its similarity with existing US ammunition. The weapon was later developed into the SA80 family of weapons which entered service with the UK. Performance: 4.85/49mm/.19cal Velocity-900mps/1952fps Effective Range-550m/600yrd For more info on the 4.85/49mm round go to↓ Info & Performance:: L 64/65 Origin-UK Length (Gun)-30.3inches/77cm Barrel- 20.4inches/51.8cm-4groove r/hand weight- 8.5lbs/3.9kg Cal-4.85/49mm Operation-Gas tapping cylinder Feed-20round box Cycle rate-?/fires safe,semi auto, 3rd burst
- The L64 was an intermediate calibre British bullpup layout prototype assault rifle developed in the 1970s. At one time it was known as the 4.85 Individual Weapon, a reference to the calibre of the bullet it fired. The British Army had considered bullpup designs with intermediate calibre rounds in the 1950s, and officially adopted one of these as .280 British in 1951 in the EM-2 and Taden gun. However, US intransigence during NATO standardization efforts, and Winston Churchill's interest in standards above all, led to the adoption of the 7.62×51mm NATO round. This was significantly more powerful than the .280, and could not be easily adapted to the existing weapons. Instead, the British and Canadian armies adopted the L1A1 SLR, a licensed version of the FN FAL, itself originally designed for the .280. During the 1960s the US found that, as the British had suggested, the 7.62 NATO round was far too powerful to be used in a fully automatic rifle. After considerable wrangling, the US Army eventually adopted the M16 rifle, firing the .223 Remington cartridge of much lower power than even the .280. With standardization "broken", the British Army once again started researching lighter rounds in the 1970s. These efforts suggested that a round of similar weight as the M16s, but firing a smaller diameter bullet, would offer the same recoil patterns while having much better penetration and ballistics. The result was the .190-inch (4.85 mm) round fitted in "necked down" but otherwise standard 5.56 mm cartridges from the M16. The Royal Small Arms Factory developed a rifle to fire the new round. The new L64/65 "Individual Weapon" was outwardly similar to the earlier EM-2, but adopted a firing mechanism very similar to ArmaLite's latest AR-18 design. The first examples were available in 1972. By 1976, NATO was ready to standardize on a small calibre round, and testing of the various rounds head-to-head started in 1977. As designed, the British round out-performed the standard US 5.56 mm. However Fabrique Nationale's entry based on the 5.56 mm, the "SS-109" performed as well as the British cartridge. In the end it was selected largely due to its similarity with existing US ammunition. The L64 pattern was later developed into the SA80 family of weapons, which entered service with the UK in the 1980s.
|
![[RDF Data]](/fct/images/sw-rdf-blue.png)