About: Admiralty scaffolding   Sponge Permalink

An Entity of Type : owl:Thing, within Data Space : 134.155.108.49:8890 associated with source dataset(s)

Of a number of similar designs, by far the most common was designated obstacle Z.1. This design comprised upright tubes high and apart, these were connected by up to four horizontal tubes. Each upright was braced by a pair of diagonal tubes, at about 45°, to the rear. wide sections were preassembled and then carried to the sea to be placed in position at the half tide mark as an obstacle to boats. The problem of securing the barriers on sand were overcome by the development of the sword picket by Stewarts & Lloyds – this device was later known at the Admiralty as the Wallace Sword.

AttributesValues
rdfs:label
  • Admiralty scaffolding
rdfs:comment
  • Of a number of similar designs, by far the most common was designated obstacle Z.1. This design comprised upright tubes high and apart, these were connected by up to four horizontal tubes. Each upright was braced by a pair of diagonal tubes, at about 45°, to the rear. wide sections were preassembled and then carried to the sea to be placed in position at the half tide mark as an obstacle to boats. The problem of securing the barriers on sand were overcome by the development of the sword picket by Stewarts & Lloyds – this device was later known at the Admiralty as the Wallace Sword.
sameAs
dcterms:subject
dbkwik:military/pr...iPageUsesTemplate
abstract
  • Of a number of similar designs, by far the most common was designated obstacle Z.1. This design comprised upright tubes high and apart, these were connected by up to four horizontal tubes. Each upright was braced by a pair of diagonal tubes, at about 45°, to the rear. wide sections were preassembled and then carried to the sea to be placed in position at the half tide mark as an obstacle to boats. However, trials found that a 250 ton barge at or an 80 ton trawler at would pass through the obstacle as if it were not there and a trawler easily pulled out one bay with an attached wire rope. Tests in October 1940, confirmed that tanks could only break through with difficulty, as a result Z.1 was adopted as an anti-tank barrier for beaches thought suitable for landing tanks. As an anti-tank barrier it was placed at or just above the high water point where it would be difficult for tanks to get enough momentum to break through the barrier. In some places, two sets of scaffolding were set up, one in the water against boats and one at high water against tanks. The problem of securing the barriers on sand were overcome by the development of the sword picket by Stewarts & Lloyds – this device was later known at the Admiralty as the Wallace Sword. Barriers varying in length from a couple of hundred feet to three miles were constructed consuming 50% of Britain's production of scaffolding steel at an estimated cost of £6,600 per mile (equivalent to £ today). Despite this, many miles of Admiralty scaffolding were erected using more than of scaffolding tube. After the war, the scaffolding got in the way of swimmers. Very soon, the scaffolding was removed for scrap and any remaining traces are now very rare, but are occasionally revealed by storms.
Alternative Linked Data Views: ODE     Raw Data in: CXML | CSV | RDF ( N-Triples N3/Turtle JSON XML ) | OData ( Atom JSON ) | Microdata ( JSON HTML) | JSON-LD    About   
This material is Open Knowledge   W3C Semantic Web Technology [RDF Data] Valid XHTML + RDFa
OpenLink Virtuoso version 07.20.3217, on Linux (x86_64-pc-linux-gnu), Standard Edition
Data on this page belongs to its respective rights holders.
Virtuoso Faceted Browser Copyright © 2009-2012 OpenLink Software