This HTML5 document contains 13 embedded RDF statements represented using HTML+Microdata notation.

The embedded RDF content will be recognized by any processor of HTML5 Microdata.

Subject Item

n17:

n16:

n2:

Subject Item

n15:

n16:

n2:

Subject Item

n18:

n16:

n2:

Subject Item

n2:

rdfs:label

Body-on-frame

rdfs:comment

Body-on-frame is an automobile construction technology. Mounting a separate body to a rigid frame that supports the drivetrain was the original method of building automobiles, and its use continues to this day. The original frames were made of wood (commonly ash), but steel ladder frames became common in the 1930s. The Lincoln Town Car dominates the American limousine market because it is the last American luxury car made with body-on-frame, and therefore easily lengthened for livery work.

owl:sameAs

dbr:Body-on-frame

dcterms:subject

n4: n5: n9:

n11:wikiPageUsesTemplate

n12: n13: n14:

n8:abstract

Body-on-frame is an automobile construction technology. Mounting a separate body to a rigid frame that supports the drivetrain was the original method of building automobiles, and its use continues to this day. The original frames were made of wood (commonly ash), but steel ladder frames became common in the 1930s. In the USA the frequent changes in automobile design made it necessary to use a ladder frame rather than monocoque to make it possible to change the design without having to change the chassis, allowing frequent changes and improvements to the car's bodywork and interior (where they were most noticeable to customers) while leaving the chassis and driveline unchanged, and thus keeping cost down and design time short. It was also easy to use the same chassis and driveline for several very different cars. Especially in the days before computer-aided design, this was a big advantage. Most small passenger vehicles switched to monocoque construction in the 1960s, but the trend had started in the 1930s with cars like the Opel Olympia, and Citroen Traction Avant leaving just trucks, some bus manufacturers and large cars using conventional frames. The switch continued for several decades - even small SUVs typically use this construction method today. Body-on-frame remains the preferred construction method for heavy-duty commercial vehicles, especially those intended to carry or pull heavy loads, such as trucks. A halfway house to full monocoque construction was the 'semi-monocoque' used by the Volkswagen Beetle and Citroen 2CV. These used a lightweight separate chassis made from pressed sheet steel panels forming a 'platform chassis', to give the benefits of a traditional chassis, but with lower weight and greater stiffness. Both of these chassis were used for several different models. Volkswagen made use of the bodyshell for structural strength as well as the chassis - hence 'semi-monocoque'. The Lincoln Town Car dominates the American limousine market because it is the last American luxury car made with body-on-frame, and therefore easily lengthened for livery work.